Trijicon RMR / SRO, Holosun 407c / 507c Sight Mount for Glock

DESCRIPTION

Mounting Hardware is Included

This EGW Mount for Glock - for the Trijicon RMR / SRO, Holosun 407c / 507c will fit all generation listed below:

• Glock 17
  
• Glock 17L
  
• Glock 19
  
• Glock 19x
  
• Glock 20
  
• Glock 21
  
• Glock 22
  
• Glock 23
  
• Glock 24
  
• Glock 26
  
• Glock 27
  
• Glock 29
  
• Glock 30
  
• Glock 30 SF
  
• Glock 31
  
• Glock 32
  
• Glock 33
  
• Glock 34
  
• Glock 35
  
• Glock 36 (Our mount is wider than the slide, but it will still work)
  
• Glock 37
  
• Glock 38
  
• Glock 39
  
• Glock 41
  
• Glock 42 (Our mount is wider than the slide, but it will still work)
  
• Glock 43 (Our mount is wider than the slide, but it will still work)
  
• Glock 43x (Our mount is wider than the slide, but it will still work)
  
• Glock 44
  
• Glock 45
  
• Glock 46
  
• Glock 48 (Our mount is wider than the slide, but it will still work)
  
• Canik TP9 SF
  
• Canik TP9 SA
  
• Bersa BP9CC
  
• Tactical Solutions .22lr Conversion
  
• Taurus G3c
  
• Taurus GX4 (non optic ready slide)
  
• Advantage Arms .22lr Conversion
  
• PSA Dagger (NON-optics ready)

Does not fit ANY/ALL Glock MOS models.

Does not fit ANY/ALL Glock slides that are already cut for optics.

This mount will also fit the NON-optics ready PSA DAGGER

SPECIFICATIONS

• Material: 7075 Aluminum
  
• Coating: Matte Black Hardcoat
  
• Overall Length: 1.780"
  
• Overall Width: 1.1"
  
• Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.