Sig P365x/xl/xmacro/365-380/322 Holosun EPS Carry, SCS Carry Screws - Set of 4

Use these torx screws to mount the Holosun EPS Carry or SCS Carry on your Sig P365 or P322 without using the included EPS Carry shim plate. This will allow your optic to sit lower on your slide.

When you install the Holosun EPS Carry on your Sig P365 or P322 you fill find that the included screws are a hair too short so the optic won't lock down properly unless you use the included shim plate.

These screws are slightly shorter so they will let you tighten the Holosun EPS Carry onto your Sig P365 or P322 without the need for the shim plate.

Screws are for the following models:

• Sig P365X
• Sig P365XL
• Sig P365 X-Macro
• Sig P365-380
• Sig P322

If you have a California Compliant P365, select the CA P365 screw set in the drop down. This specific model uses a shorter screw than the other P365 models mentioned. 

Screws are M3 screws and have a T8 Torx Head which is different than the included Holosun Tool. You'll need to make sure you have a T8 Torx bit or key.

Sometimes our torx head supplier is unable to fulfill our orders. In that case we may send hex head screws of similar quality instead. They use a 2MM hex key.

*screws ship USPS*

Screws do not include threadlocker - we recommend using a dab of purple or blue threadlocker when installing. Save 40% on threadlocker when you add any screw set and threadlocker to the same order!

*Screws are not returnable*